Selfie Ring Light Tutorial #4: Front Cover

Step 8: Reinforce Ring Cutout

The part of the cover over the LED Ring is very thin.
Let’s make it a bit stronger by angling the edges in.

  1. Check again that the Front Cover component is active.
    (Yes, check again. It is a good habit)
  2. Select the Chamfer tool from Modify > Chamfer in the Toolbar.
  3. Click on the outer edge of the cutout,
    Drag the arrow in until it looks good, maybe 1 mm.
    Click on OK to create the feature.
  4. Select the Chamfer tool again.
  5. Click on the inner edge of the cutout,
    Drag the arrow up until it looks good, maybe 2 mm.
    Click on OK to create the feature.
  6. Hide the Cross Section to show the whole design again.
    (Click on the  icon next to  ‘Section1’ in the Browser)

We’re almost done!

Troubleshooting

Leave a Reply

Your email address will not be published. Required fields are marked *